HTC Wildfire E Plus Runs on Android 12 and is Powered by Mediatek MT6739 Processor. it is a dual SIM smartphone that supports a Nano SIM card, connectivity Option Include GPS, WIFI, hotspot, Bluetooth 3G 4G, etc. the device comes with 2GB of RAM and 32GB of storage that can be expandable via SD card.

Rooting is the way to obtain Supersu Rights on an Android device, which means after Rooting the Phone you have (Sudo) full Rights to perform any system task.

Required:

• Vbmeta.img
• unlock the bootloader
• ROM2box and required USB driver: Download
• Magisk boot.img = boot.img/bin boot_a.bin boot_b.bin

Note:

• All data will be erased on your phone, must make a backup before the process
• After unlocking the bootloader must write vbmeta.img
• If the device has a vendor_boot partition, patch & flash it too
• We strongly suggest the below method (boot.img dump) because boot.img from a different firmware version may cause a boot loop or restart problem
• The boot image is NOT the bootloader image. do not confuse between them flashing the wrong image to the bootloader could brick your device.

How to Root HTC Wildfire E Plus:

• Install USBDK and Mediatek driver on Your computer
• Download & Extract ROM2box
• Run ROM2Box.exe
• Click Mediatek/Firmware Reader!
• mark “Full Firmware”
• Click the ‘START’ button
• Once the process started, turn the phone OFF, Now together Press Volume up + down keys & Insert USB, Once Phone detected Immediate Release keys (make sure your phone is stable in the device manager)
• done, it will take 15-20Min
• Move boot.bin (or if any boot_a or boot_b) (rename it boot.img) from ROM2box/out folder to your phone
• on Phone Install Magisk Manager

• Now patch boot.img using Magisk and Move back to the computer, Platform tools, or ROM2box folder
• Open ROM2Box.exe Go to Mediatek/Firmware Flasher/Flash Single Partition
• click Select file and locate “Magisk_Patched_boot.img”
• Now mark boot.img

• Click the ‘START‘ button
• Once the process started, turn the phone OFF, Now together Press Volume up + down keys & Insert USB, Once Phone detected Immediate Release keys (make sure your phone is stable in the device manager)
• Follow the same and flash vbmeta.img.empty from ROM2box folder (in this time you have to click vbmeta.img)
• done.

Note: if any boot_a or boot_b partition is in the device then flash it to the respective section for that go to firmware flasher, click open dedicated GUI, connect the phone, load the patched file to under the respective boot_a or boot_b section, and click ‘Write Partition‘